Kit 3GB PC1066 DDR3 - 7-7-7 - (Kit 3 x 1GB) - KINGSTON

DDR3 DIMM 3GB(3X1GB) 1066MHZ 7-7-7 KINGSTON KVR1066D3N7K3/3G

ValueRAM's KVR1066D3N7K3/3G is a triple-channel kit consisting of three 128M x 64-bit 1GB (1024MB) DDR3- 1066 CL7 SDRAM (Synchronous DRAM) memory modules, based on eight 128M x 8-bit DDR3-1066 FBGA
components per module. Total kit capacity is 3GB (3072MB). The SPDs are programmed to JEDEC standard latency 1066Mhz timing of 7-7-7 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:

JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
533MHz fCK for 1066Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 6,7,8,9
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7(DDR3-1066)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address 000 only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C Asynchronous Reset
PCB : Height 1.180 (30.00mm), single sided component

CL(IDD) 7 cycles
Row Cycle Time (tRCmin) 50.63ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin) 110ns
Row Active Time (tRASmin) 37.5ns (min.)
Power 1.020 W (operating per module)
UL Rating 94 V - 0
Operating Temperature 0° C to 85° C
Storage Temperature -55° C to +100° C